Even neatly bundled wiring has to be traced wire by wire months later if nobody knows which wire belongs to which circuit. A marker cable tie is a cable tie with a small label attached. Labeling is done the moment you fasten it, so there is less separate labeling and less worry about labels falling off. Based on the Allpum marker cable tie (APMK) specifications, here is where and how to use it.
Allpum marker cable tie specifications
| Item | Length | Width, thickness | Marker pad | Tensile strength | Packing |
|---|---|---|---|---|---|
| APMK-1M | 105mm | 2.5 · 1.2mm | 25.4 × 8.1mm | 80N / 8.1kgf | 1,000 per bag · 25 bags per box |
| APMK-2M | 200mm | 2.5 · 1.2mm | 25.4 × 8.1mm | 80N / 8.1kgf | 1,000 per bag · 15 bags per box |

Where it helps
- Circuit labels in distribution panels Write the circuit name on each wire leaving a breaker, and you can find it at once during inspection or expansion.
- LAN and telecom cables Where many cables of the same color run together, write the connection point near each end.
- Identifying wires and circuits Mark the original position on wires that will be moved or reconnected to reduce reconnection mistakes.
- Tags for materials and samples Beyond wiring, use it as a hang tag on material bundles or samples with the item name and date.
Making labels last
- Use a permanent marker Water-based ink can smudge with handling or moisture. Write clearly with a permanent marker.
- Write before fastening Writing while the pad is flat gives even lettering and avoids trying to reach a pen into a tight spot.
- Short, consistent names The pad is 25.4 × 8.1 mm. Agree on abbreviations that match the drawings and breaker labels, and write them the same way every time.
- Face it outward Turn the pad toward whoever will inspect before tightening. A tag at each end makes the wire easy to find from either side.
Using it with standard cable ties
APMK is a slim tie — 2.5 mm wide with a tensile strength of 80 N (8.1 kgf), similar to AP100. Rather than relying on it alone for thick, heavy bundles, it is safer to hold the bundle with standard cable ties (AP series) sized for the load and add a marker tie as the label. At 2.5 mm wide it also fits the APTM-2S screw mount (tie width 2.5–4.8 mm) and the APTM-19 and 25 adhesive mounts.
- Choosing a length Use 105 mm (APMK-1M) for one or two thin wires or small bundles, and 200 mm (APMK-2M) around larger bundles. Wrapping a sample around the bundle settles it.
- Trimming the tail After tightening, cut the tail flush with the head. A sharp leftover end can cut hands during inspection.
- Operating temperature The operating range is -40 to 85 °C. Keep it away from heat sources, and replace the tie when the label needs to change.
Allpum marker cable ties are China OEM products. The UL94 V-2 in the material information is the flame rating of the raw material (nylon 66), not a certification of the finished product. How to combine cable ties, mounts and clamps in switchboards and distribution panels is covered in the post below.






